The temperature needle crept up on the highway, the coolant reservoir is low again for no visible reason, and now the shop has called with a number: a little over $3,000. That quote is probably not a rip-off. RepairPal’s estimator, updated September 2026, puts the average head gasket replacement at $2,572 to $3,386 before tax, with $1,669 to $2,449 of that in labor and only $903 to $937 in parts. For 2027 planning, that is the national baseline.
The total matters less than what sits inside it. Below we take a sample repair order apart line by line, show which charges are fixed by the engine’s design and which are a shop’s judgment call, and flag the add-ons that deserve a second question. If you want a quick number for your own car first, our car repair cost estimator gives a starting range.
A sample head gasket repair order, taken apart
This is a hypothetical invoice for an inline four-cylinder sedan, the most common head gasket job in America. We built it from the published averages cited in this article, not from a real customer’s bill, and it lands almost exactly where RepairPal’s national range says it should.
| Line on the repair order | Basis | Example charge |
|---|---|---|
| Diagnosis: cooling system pressure test and combustion leak check | 1 hour at $132 | $132 |
| Labor: remove and reinstall cylinder head, replace gasket | 14 hours at $132 | $1,848 |
| Parts: head gasket set, new head bolts, coolant, oil and filter | RepairPal parts average | $920 |
| Machine shop: check flatness, resurface head, pressure-test it | Published starting prices | $225 |
| Total before tax and shop fees | $3,125 |
Source: parts and labor ranges from RepairPal (September 2026); hourly rate from Tekmetric’s June 2026 national average; machine work from one shop’s published price list. Taxes, shop supply fees and disposal charges are not included.
Read the table from the bottom up and one fact jumps out: the gasket itself is a rounding error. Nearly two-thirds of the bill is a technician’s time spent getting the cylinder head off and back on, and almost everything else on the order exists to make sure that time is not wasted.
Labor: the 14 hours you are really paying for
A head gasket sits between the engine block and the cylinder head, under the intake manifold, exhaust manifold, valve cover, camshafts and, on many engines, the timing belt or chain. Reaching it means unbolting most of the top half of the engine, and that is why shops quote it by the hour rather than by the part. Divide RepairPal’s labor range by a typical shop rate and you get roughly 12 to 19 billed hours, our estimate, depending on the engine.
The rate you multiply those hours by depends heavily on where you live. Tekmetric’s 2026 state-by-state data puts the national average at $132 an hour, with West Virginia near the bottom of its table at $100 and Alaska at the top at $161. California shops average $156. On a 14-hour job, the spread between a $100 shop and a $161 shop is about $850 for identical work.

Shop prices kept climbing through 2026, though more slowly than in the post-pandemic surge. The Bureau of Transportation Statistics’ August 2026 release shows motor vehicle maintenance and repair prices up 1.6% from a year earlier. Nothing specific to head gasket labor has been announced for 2027, so budget the 2026 figures plus a modest cushion rather than assuming a big jump.
One fair question to ask about the labor line: is the shop quoting book time or its own estimate? Most independents bill from a labor guide, which is a fixed number of hours for your engine regardless of how fast the technician works. If two quotes differ by more than a few hours on the same car, ask each shop what the guide says.
Parts and machine work: the small lines that protect the big one
The parts line covers more than one gasket. A proper job uses a full head set (intake, exhaust and valve cover gaskets plus seals), new head bolts on engines whose torque-to-yield bolts stretch and cannot be reused, fresh coolant and an oil change to flush out any coolant that got into the crankcase. RepairPal’s $903 to $937 parts range reflects that whole kit, which is why it varies so little from car to car.
The machine shop line is where a careful shop separates itself. An engine that overheated badly enough to blow a gasket may have warped the head, and a new gasket on a warped head will fail again. One performance machine shop’s published price list starts resurfacing at $150 for a six-cylinder head and $225 for a pair of V6 or V8 heads, with a $75 pressure test to check for cracks. If your estimate has no machine work at all, ask how the shop plans to confirm the head is flat. A straightedge check is fine; skipping the question is not.
Parts run $903 to $937 on the average head gasket job. Labor runs $1,669 to $2,449.
RepairPal head gasket estimate, September 2026
Why a pickup or a V6 SUV can cost double
Engine layout moves the labor line more than anything else. An inline four has one head and one gasket. A V6 or V8 has two of each, and in a crowded engine bay the rear head may sit under the cowl or require pulling the engine. The model-level ranges below show how far that pushes the total.
| Vehicle | Typical head gasket replacement range |
|---|---|
| Chevrolet Silverado 1500 | $1,989 to $2,544 |
| Honda Civic | $2,275 to $3,099 |
| Honda Accord | $2,294 to $2,971 |
| Nissan Altima | $2,457 to $3,281 |
| Toyota Corolla | $2,463 to $3,329 |
| Honda CR-V | $2,609 to $3,494 |
| Toyota Camry | $2,800 to $3,773 |
| Ford F-150 | $3,474 to $4,603 |
| 2020 Lexus RX350 AWD, both sides (Tulsa quote) | $5,964 to $8,109 |
Source: RepairPal model estimates (September 2026); Lexus figure from ConsumerAffairs’ 2026 head gasket cost guide, which quotes RepairPal for Tulsa, Oklahoma.
The Silverado’s low range surprises people, but its V8 has roomy access on both sides. The Lexus is the opposite case: a transverse V6 with the rear bank tucked against the firewall, and both gaskets replaced at once. If you own a V-engine, make sure the quote covers both heads. Replacing only the failed side saves money today and often buys a second teardown later.
The extra lines on the estimate: accept, question or decline
Once the head is off, a good shop will suggest replacing parts that share the same labor. Some of those suggestions save real money; others are padding. A quick way to sort them:
- Timing belt and tensioner (accept, on belt engines). The belt usually has to come off anyway. Done on its own, a timing belt replacement averages $918 to $1,338 at RepairPal, nearly all labor; added to a head job, you mostly pay for the parts.
- Water pump and thermostat (usually accept). If the pump is driven by the timing belt, replacing it now avoids paying the same labor twice. A thermostat is cheap insurance after an overheat.
- Valve job (question). Worth it if the machine shop finds leaking or burned valves. The machine shop list cited above starts a V8 valve job at $300. Ask to see the measurements before you approve it.
- Radiator, hoses, cooling system flush (question). Fair if the radiator caused the overheat or is clogged. Ask what failed first.
- A replacement cylinder head (question hard). Needed only if the head is cracked or too warped to machine. RepairPal’s cylinder head estimate runs $4,241 to $5,101, so a shop that jumps straight there owes you a pressure-test result.

A $32 bottle, a $3,000 repair or a trip to the scrapyard
Every head gasket conversation eventually reaches the bottle on the auto parts shelf. A 16-ounce BlueDevil head gasket sealer lists at $32.49 at Auto Barn, roughly one percent of the repair. The professional view is blunt. The Drive notes that sealers do not fix anything; they temporarily plug a leak that will eventually fail again. RepairPal warns that these additives can clog a radiator or damage a water pump. A sealer can make sense on a car you plan to sell or scrap within months. It is a poor bet on a car you want to keep.
For an older car, the useful test is The Drive’s three questions: does the repair cost more than the car is worth, does it cost more than a replacement engine, and does a replacement engine cost more than the car? If the answer to all three is yes, the money is better spent elsewhere. A car worth $9,000 with a sound body and transmission is usually worth a $3,000 repair. A car worth $2,500 with 200,000 miles usually is not, unless you know its history and plan to drive it for years.
Bottom line on a $3,000 head gasket quote
A fair four-cylinder quote for 2027 falls between about $2,500 and $3,400; a V6 or V8 can reach $4,500 or more, and a tight transverse V6 can top $8,000. Judge the quote on three lines rather than the total: labor hours that match the labor guide for your engine, a parts list that includes a full head set and new bolts, and some plan to check the head for flatness. If those three are there, the shop is doing the job properly, and the cheapest place to save is the hourly rate, so get a second quote from an independent shop before you approve a dealer price.
Head gasket questions owners ask next
How long does a head gasket replacement take?
RepairPal says the process typically takes several days. The labor itself is often 12 to 19 billed hours on common engines, by our estimate, but machine shop turnaround and parts orders add calendar time, so ask the shop for a completion date along with the price.
What are the signs of a blown head gasket?
Common signs include coolant loss with no visible leak, white exhaust smoke with a sweet smell, overheating, bubbles in the coolant reservoir and milky residue in the oil. Several of these can also come from other faults, so a mechanic should confirm with a cooling system pressure test or combustion leak test before you pay for head gasket repair.
Can I keep driving with a blown head gasket?
It is risky. A leaking head gasket can let the engine overheat quickly, which can warp the cylinder head or damage the engine and turn a $3,000 head gasket repair cost into an engine replacement. If you see overheating or heavy white smoke, stop driving and have the car inspected.
How long should a head gasket last?
ConsumerAffairs says head gaskets typically last at least 100,000 miles, and The Drive puts their life at 10 years or more, sometimes 15-plus. Early failures are usually caused by overheating, so a failed radiator, fan or water pump should be fixed at the same time.
Does car insurance or a warranty pay for head gasket replacement?
Standard auto insurance generally does not cover mechanical failures like a blown head gasket. A factory powertrain warranty or an extended service contract may, depending on its terms and whether maintenance was kept up. Read the contract and call the provider before work starts, since many require approval in advance.
Price sources
- Head Gasket Replacement Cost Estimate, RepairPal (updated September 3, 2026)
- Cylinder Head Replacement Cost Estimate, RepairPal (updated September 3, 2026)
- Head Gasket Replacement Cost (2026), ConsumerAffairs (updated May 28, 2026)
- Average Auto Repair Labor Rates by State (2026 Data), Tekmetric (June 30, 2026)
- Transportation Consumer Price Index, August 2026, Bureau of Transportation Statistics (September 11, 2026)
- Machine Shop: Services and Pricing, Mr. Horsepower (prices effective June 1, 2024)
- Blue Devil Head Gasket Sealer, 16 oz, Auto Barn
- How To Deal With a Blown Head Gasket, The Drive
More engine and drivetrain repair prices
- Car ownership costs in 2027: the complete guide
- Timing belt replacement cost by engine and model
- Transmission fluid change vs flush cost
- Alternator replacement cost
- Oil change cost per visit and per year
- Car repair cost estimator
More related guides: Transmission replacement cost, from junkyard to new
Pricing method: prices were researched in November 2026 for 2027 planning and may change. The sample repair order is a hypothetical example built from published averages, not a real invoice; your local labor rate, engine and the condition of the cylinder head will change the total. Get a written estimate from a licensed shop. See our disclaimer.
















