The most common way food truck owners overpay for a wrap is by taking the lowest quote, then paying again two summers later when unprotected vinyl starts fading and lifting at the edges. A complete full wrap on a 14- to 16-foot truck generally runs $3,500 to $5,500, according to builder Zion Food Trucks, while Ardor Printing quotes $4,500 to $8,500 or more for a full-size truck or step van. Wrapmate, the national wrap marketplace, lists full food truck wraps starting at $5,000 and 25 percent partial wraps from $1,249.
Those ranges are wide because a wrap quote is really six separate jobs stapled together. The quickest way to judge one is to take it apart, so below you will find a sample quote for a 16-foot step van, clearly hypothetical but built from the line-item ranges shops publish, with what each line should cost and which ones tend to carry padding. The same math works for a 20-foot trailer.
Full-wrap prices by truck and trailer length
Start with the size of the canvas. These are full-wrap ranges that builders and print shops published in 2026. Partial wraps come later.
| Vehicle | Full wrap | Published by |
|---|---|---|
| 6×12 enclosed trailer | $1,500 to $3,000 | Ardor Printing |
| 7×14 enclosed trailer | $2,000 to $4,000 | Ardor Printing |
| 16- to 20-foot food trailer (design extra) | $2,000 to $4,000 | Golden State Trailers |
| 14- to 16-foot food truck | $3,500 to $5,500 | Zion Food Trucks |
| 22- to 30-foot trailer (design extra) | $3,500 to $6,000 | Golden State Trailers |
| Concession or food trailer | $3,800 to $7,500+ | Ardor Printing |
| Food truck or step van | $4,500 to $8,500+ | Ardor Printing |
| 22-foot truck or trailer | $5,500 to $8,500 | Zion Food Trucks |
Golden State’s figures leave out design, which it prices at $300 to $1,000 on top, so compare like with like. For a rough cross-check, VehicleWrapPricingCalculator.com assumes about 320 square feet of wrappable surface on a food truck and an all-in rate of $15 per square foot, which comes to $4,800. In California, food truck broker Paul Somerhausen of SactoMoFo puts the range at $3,000 to $6,000 in a guest article on 3M’s site, or about 3 to 5 percent of a $75,000 to $100,000 startup budget.
A sample $8,550 quote, taken apart
The quote below is a hypothetical example for a 16-foot step van that still carries a previous owner’s lettering. Every line sits inside the ranges Zion Food Trucks publishes for that size, which is exactly why padding is hard to spot: each number looks plausible on its own. The middle column shows a leaner version of the same job.
| Line item | Sample quote | Leaner version | Published range |
|---|---|---|---|
| Custom design, unlimited revisions | $1,200 | $600 | $300 to $1,800 |
| Printed cast vinyl, about 300 sq ft | $2,100 | $1,800 | $1,000 to $2,200 |
| UV laminate | $750 | $500 | $400 to $800 |
| Surface prep and cleaning | $400 | $300 | $200 to $400 |
| Installation, 2 to 3 days | $3,200 | $2,400 | $1,800 to $3,500 |
| Removal of old graphics | $900 | $0 on a bare truck | $500 to $1,200 |
| Total | $8,550 | $5,600 |
The $2,950 gap does not come from one outrageous charge. It comes from five moderately high ones plus a removal fee that may not apply to your truck. Each line deserves its own question.
Line 1: artwork, and who keeps the file
Zion puts simple wrap design at $300 to $700 and complex full-truck artwork at $800 to $1,800. Golden State quotes $300 to $1,000 for print-ready files. Wrapmate charges $199 for custom design, credited toward the wrap, with up to three revisions; in November 2026 it was running a $49 Black Friday price on that design fee.
A $1,200 design line is fair for illustrated, menu-heavy artwork built from scratch. It is padding if you already have a logo and brand colors and only need a layout. Bring your own print-ready files and Zion estimates you save $500 to $1,200. Two questions settle this line: how many revision rounds are included, and will you receive the layered source files, so a future reprint or a new menu panel does not mean paying for design twice.

Lines 2 and 3: the film, and the laminate you should not cut
Print and material is the line most owners expect to dominate, yet on a professionally installed wrap it usually trails labor. Zion prices printed cast vinyl at $4 to $9 per square foot plus laminate, or roughly $1,000 to $2,200 for the 250 to 320 square feet on a 16-foot truck. Cheaper calendared vinyl runs $1.50 to $3 per square foot, but Zion gives it 18 to 30 months on a working truck, against five to seven years for cast film with laminate.
Laminate, the clear protective layer over the print, adds $400 to $800. Zion’s own advice is blunt: a suspiciously cheap quote probably left it out. On a truck that sits in full sun all afternoon and gets scrubbed after every service, unlaminated print is the false economy that leads to a second wrap. Ask for the film and laminate by name, such as a 3M or Avery Dennison cast wrap film with its matching overlaminate, since manufacturer warranty programs generally depend on matched materials and approved installation. Wrapmate, for one, advertises up to a five-year warranty on 3M material only when one of its own installers does the job.
Specialty films are a separate budget. Chrome runs $12 to $25 per square foot in Zion’s figures, so treat it as an accent stripe, not a paint color for the whole box.
Lines 4 to 6: prep, removal and two days on the shop floor
Installation is the biggest line for good reason. Zion’s labor range for a 16-foot truck is $1,800 to $3,500 over two to three days, and skilled installers bill $80 to $130 an hour. Food trucks are harder to wrap than delivery vans: Ardor Printing lists rivets, ribs, seams, serving windows and hatches, exhaust vents and textured panels as the features that push its quotes up, and some panels near the heat simply will not hold vinyl.

Prep, at $200 to $400, covers degreasing and cleaning so the adhesive bonds. That charge is fair; skipping it is how edges lift beside the fryer exhaust. Removal is the line to verify with your own eyes. Stripping old graphics costs $500 to $1,200 in Zion’s estimate, and Ardor quotes it separately. If your truck is bare or freshly painted, the line should read zero. If it wears a sun-baked wrap from a previous owner, expect the high end, because old vinyl tends to come off in flakes rather than sheets.
One more labor question: is installation included at all? Golden State warns that some vendors split printing and installation, so a low print-only number can grow into a much larger bill once you find someone to put it on. Reprints after a botched install are expensive too, and Somerhausen’s warning on 3M’s site holds: doing it twice costs more.
Half the truck for roughly half the money
A partial wrap pairs printed graphics with the truck’s existing paint. Zion prices a logo-and-name partial on a painted base at $1,500 to $3,000, Golden State starts partials at $800 to $2,000, and Wrapmate’s 25 percent coverage package starts at $1,249. Ardor says partials cost roughly half as much as full wraps, and Golden State estimates a well-designed one delivers 60 to 80 percent of the visual impact.
Partials work best when the base paint is sound and a solid color that suits the brand. They work worst on a faded, patched or multi-color used truck, where the print has to hide flaws and you end up buying most of a full wrap anyway. Plan the layout around the paperwork, too: Ardor advises keeping key text off swinging hatches and leaving clear space for the permit and inspection decals your city requires.
Wrap or paint over the life of the truck
Paint is the alternative many owners price right after their first wrap quote. Over a long horizon, the comparison is closer than the sticker prices suggest.
Vinyl wrap
$3,500 to $8,500+ for a full wrap, installed in one to three days. Lasts about five to seven years with laminate and care. A re-wrap on a truck wrapped six or more years earlier runs $4,000 to $7,500, and a damaged panel can be reprinted for $80 to $200 instead of redoing a whole side.
Custom paint
$8,000 to $20,000+ in Zion’s figures, with three to six weeks in the shop. Lasts 10 to 15 years. A new logo, menu or concept means repainting, and the truck earns nothing while it sits in the booth.
Two wraps over a dozen years can cost about as much as one custom paint job, but they bring two chances to rebrand and far less downtime. Paint makes more sense for a long-running concept with a simple design that will not change. For 2027, no film maker or national installer had announced price changes as of November 2026, so the figures here are current published rates. Anyone launching next spring should still lock in design early, because artwork approval, not installation, is usually what holds up the schedule. If you have priced a car paint job before, expect a step van to cost several times more.
One rule for comparing wrap quotes
Put every quote in the same six rows: design, film, laminate, prep, installation and removal. If a shop cannot break its number down that way, ask for it in writing until it does. A full-wrap quote well under $3,500 for a 16-foot truck that does not name its laminate is not a bargain, and one above $8,500 should be explaining chrome, heavy removal or an unusually complicated body. Everything in between is negotiable one line at a time, and the line most worth pushing on is usually the one you can supply yourself: the artwork.
Questions owners ask once the quote arrives
Can a food truck wrap be written off as a business expense?
Often, because a wrap works as both advertising and vehicle equipment, but whether it is deducted in one year or depreciated depends on how it is classified and on your own tax situation. Confirm the treatment with a CPA before you count on either.
How should I wash a wrapped food truck around the kitchen exhaust?
Hand wash with mild soap and water. Ardor Printing advises keeping pressure washer nozzles away from film edges and avoiding heavy solvent degreasers near the kitchen, since both can lift or cloud the vinyl over time.
How much does it cost to wrap a food truck that has rust or dents?
Plan on bodywork first, priced separately. Vinyl follows the surface underneath, so it shows dents and does not stop rust, and a wrap shop’s prep charge covers cleaning, not repair. Get a body shop quote before you finalize the wrap budget.
Does a food truck wrap pay for itself?
Vendors make strong claims: Wrapmate cites about $0.07 per 1,000 impressions, and SactoMoFo’s Paul Somerhausen says from his experience that a good wrap should sell about 20 percent more than an unwrapped truck. Treat these as industry estimates rather than guarantees, and judge by your own sales.
Is food truck wrap cost lower if I buy the vinyl and hire an installer myself?
Sometimes, but the savings shrink once you add design, laminate and the risk of a misprint. Golden State Trailers notes that reprints are costly, and a shop that only installs usually will not warranty film it did not print.
More costs of putting a kitchen on wheels
- Small business startup costs in 2027: the complete guide
- What a food truck costs in its first year
- Food truck permit costs, from first filing to renewal
- Food truck POS system costs and the mistakes that inflate them
- Renting a food truck by the event, day or month
- Car wrap prices by vehicle size, film and finish
- Billboard costs per month and per customer
Pricing method: prices were researched in November 2026 for 2027 planning and may change. Figures come from 2026 price guides and price pages published by Zion Food Trucks, Golden State Trailers, Ardor Printing and Wrapmate, a SactoMoFo guest article on 3M’s website and VehicleWrapPricingCalculator.com. The sample quote is a hypothetical example, not a real invoice. Get written quotes from local installers, and see our disclaimer.
















