A Bradford White is a plumber’s water heater, and its price comes in two layers: what the tank lists for at a supply house, and what it costs once someone licensed carries it down the basement stairs. On the first layer, the standard 50-gallon gas model, the RG250T6N, is listed at $1,079.80 at SupplyHouse, and the 50-gallon electric model sits just under $900. Climb to an AeroTherm heat pump or a power direct-vent gas tank and the unit alone runs $3,100 to $3,600.
Short answer for 2027 budgets: a like-for-like swap of a standard 50-gallon Bradford White should land around $1,100 to $2,500 installed, by our estimate from the listed prices and national labor ranges below. Heat pump and power-vent installs start around $3,500 and can pass $5,000.
The more useful question is which rung of the ladder your house actually needs. Bradford White makes the same 50-gallon capacity four different ways, and the price roughly quadruples from bottom to top. The hot water you get does not.
Four 50-gallon Bradford Whites, priced side by side
| Tier | Model | Listed unit price | First-hour delivery | Standard warranty |
|---|---|---|---|---|
| Standard electric | RE250T6-1NCWW, 4,500 W | $894.42 | 67 gallons | Not listed |
| Standard gas (atmospheric vent) | RG250T6N, 40,000 BTU | $1,079.80 | 81 gallons | 6 years tank and parts |
| AeroTherm heat pump | RE2H50S6-1NCWT | $3,160.80 | 65 gallons (S10 version) | Varies by model |
| Power direct vent gas | RG2PDV50S6N, 40,000 BTU | $3,585.13 | 88 gallons | 6 years tank and parts |
Read the first-hour column before the price column. It measures how much hot water the tank can deliver in a busy hour, and it is the number that decides whether the last person in the shower gets a cold rinse. The gas tank beats the electric by 14 gallons because its burner recovers faster. The power direct-vent model adds only 7 more gallons for more than three times the money, because what you are buying there is venting flexibility, not capacity.
Rung one: the electric Energy Saver at about $900
The RE250T6-1NCWW lists at $894.42 on SupplyHouse: a 240-volt tank with 4,500-watt elements and an energy factor of 0.95. Electric resistance tanks are close to 100% efficient at turning electricity into heat, which sounds better than it is. Electricity costs more per unit of heat than gas in most of the country, so this is the cheapest Bradford White to buy and usually the most expensive to run.
Fixr’s 2026 cost data puts the yearly operating cost of a 50-gallon electric tank at $600 to $750, against $325 to $475 for gas and $225 to $350 for a hybrid heat pump. If your home already has a 240-volt circuit and no gas line, this rung is the default, and the only real decision is whether to stop here or jump to rung three.
Rung two: the atmospheric gas tank most basements already have
The RG250T6N is the workhorse: 40,000 BTU, a standard draft-hood vent into an existing chimney or metal flue, 81 gallons of first-hour delivery, and a 6-year limited warranty on both tank and parts. If the old heater in your house has a vent pipe rising straight off the top into a flue, this is almost certainly the like-for-like replacement, and nothing about the venting has to change.
That is why this rung is where value stops improving for most gas households. Every step above it costs thousands more and solves a problem (venting, energy use) that a house with a working flue may not have. The one catch: SupplyHouse notes this model does not meet California’s ultra-low-NOx air rules, so buyers in those air districts need the low-NOx version of the tank.
What the plumber adds on top of the tank
Bradford White is built around the trade. Its tanks show up at plumbing supply houses such as SupplyHouse, PDI and Ferguson, and most homeowners end up buying one inside a plumber’s quote, where the unit carries the plumber’s own markup. The other lines on that quote tend to follow national ranges:
- Labor: about $180 to $1,250, typically 2 to 4 hours for a standard swap, with plumbers charging $45 to $200 an hour.
- Removal and haul-away of the old tank: $50 to $150.
- Thermal expansion tank, often required by local code on closed systems: $150 to $400.
- Permit and inspection: $25 to $1,500, depending on your city.
- Venting changes, if you move from an atmospheric flue to direct or power venting: $3,400 to $10,200.

All of those ranges come from Fixr’s 50-gallon data, which puts a typical installed 50-gallon gas heater at $900 to $2,500 and electric at $700 to $1,900 across brands. Adding the Bradford White list prices to the labor and haul-away ranges gives our estimate of roughly $1,125 to $2,300 for the electric model and $1,310 to $2,480 for the gas model, before any expansion tank, permit or plumber markup on the unit. A quote that lands well above $2,500 for a straight gas swap should come with an explanation, usually code upgrades such as a new gas shutoff, a drain pan or seismic straps where required.
Rung three: AeroTherm, the tank that pays you back
The AeroTherm series pulls heat from the surrounding air and moves it into the water, using electric elements only as backup. PDI’s spec page for the 50-gallon AeroTherm RE2H50S10 lists an energy factor of 3.44, against 0.95 for the standard electric tank, and 65 gallons of first-hour delivery. The previous-generation RE2H50S6 is listed at $3,160.80 on PDI’s site, about $2,270 more than the standard electric model.
Whether that premium comes back depends on how many people shower in your house. ENERGY STAR’s heat pump water heater savings figures, which assume electricity at 14.6 cents per kWh and a 13-year lifespan, show the spread clearly. The last column is our arithmetic using the Bradford White price gap rather than ENERGY STAR’s $1,503 assumed premium.
| Household size | Yearly savings vs. standard electric | Lifetime savings | Payback on a ~$2,270 Bradford White premium |
|---|---|---|---|
| 2 people | $270 | $2,050 | About 8.4 years |
| 3 people | $410 | $3,830 | About 5.5 years |
| 4 people | $550 | $5,610 | About 4.1 years |
A family of four clears the premium well inside the tank’s life. A couple barely does, and only if the unit lasts. Placement matters too: ENERGY STAR says heat pump water heaters belong in spaces that stay between 40 and 90 degrees year-round with about 1,000 cubic feet of air around them. A cold northern garage pushes the unit into backup electric mode for months, and the savings shrink.

The 2027 math also lost a sweetener. The federal Energy Efficient Home Improvement Credit paid up to $2,000 a year toward a heat pump water heater, but the IRS says it applies only to improvements made through December 31, 2025. A heat pump installed next year earns no federal credit, so any discount has to come from your utility or a state program. Ask before the install, since some programs require pre-approval.
Rung four: power direct vent, $2,500 more for a different pipe
The RG2PDV50S6N lists at $3,585.13 on SupplyHouse, and it was on backorder when we checked. Its burner is the same 40,000 BTU as the basic gas tank and the warranty is the same 6 years. What changes is the exhaust: a fan pushes it out through a 2-inch pipe that can run sideways through a wall, and the sealed combustion draws its air from outside.
That is worth paying for in specific houses: no usable chimney, a furnace replacement that leaves an orphaned flue, a heater in a tight closet near bedrooms, or a finished basement where a metal flue cannot go. It also needs a 120-volt outlet, and the tank stops heating when the power goes out. If none of those apply, you are paying roughly $2,500 more for the unit, and possibly thousands more in venting labor, to get 7 extra gallons in the first hour.
Paying for 10 years of coverage instead of 6
Most of the residential tanks above carry a 6-year limited warranty, and Fixr notes that standard tank warranties run 6 to 10 years across the industry. Supply-house listings show longer-warranty versions of several Bradford White models, including the AeroTherm, often marked by a “10” in the model number where the 6-year version has a “6”. The longer-warranty tank typically costs more up front. Treat it as insurance on a heater in an expensive spot: a finished basement, an attic or a closet over hardwood, where a leak costs far more than the tank.
Questions buyers ask about Bradford White pricing
Can I buy a Bradford White water heater myself?
Some online supply houses, including SupplyHouse, list Bradford White tanks with a public cart. The company focuses on professional installers, though, and gas, venting and electrical work is regulated locally. Check your city’s permit rules and confirm with the installer how the warranty is handled before buying the unit yourself.
Is a 50-gallon tank big enough for my family?
For many households of three or four, yes. Size by the first-hour rating rather than the tank volume: the standard gas RG250T6N is rated at 81 gallons in the first hour and the standard electric at 67. A larger household or a big soaking tub may need a higher-input gas model or a larger tank.
Do I need an expansion tank with a new water heater?
Often, if your home has a closed plumbing system with a check valve or pressure-reducing valve, and many local codes require one. Fixr puts the cost at $150 to $400 installed.
Is there a federal tax credit for a heat pump water heater in 2027?
Not under the Energy Efficient Home Improvement Credit. The IRS says it covers improvements made through December 31, 2025. Check your electric utility and state energy office for rebates, and confirm current rules with a tax professional.
Can an AeroTherm heat pump go in my garage?
It can in a mild climate. ENERGY STAR recommends a space that stays between 40 and 90 degrees year-round with about 1,000 cubic feet of air. In a garage that freezes, the unit relies on its electric backup elements and saves much less.
The bottom line, rung by rung
If you have gas and a working flue, the $1,080 atmospheric RG250T6N is the Bradford White to buy, and a fair installed quote sits somewhere between $1,300 and $2,500 depending on code work in your area. If you are all-electric with three or more people at home and a space that stays above 40 degrees, the AeroTherm is the one rung above the bottom that earns its premium back, even without a federal credit. The $894 electric tank makes sense for small households and cold basements, and the $3,585 power direct-vent model only when the house gives you no other way to vent. Get two written quotes that name the exact model number, because the same “50-gallon Bradford White” on a quote can mean any of these four tanks.
Price sources
- Bradford White RG250T6N 50 Gallon 40,000 BTU Atmospheric Water Heater, SupplyHouse (checked November 2026)
- Bradford White RE250T6-1NCWW 50 Gallon Energy Saver Electric Water Heater, SupplyHouse (checked November 2026)
- Bradford White RG2PDV50S6N 50 Gallon Power Direct Vent Water Heater, SupplyHouse (checked November 2026)
- Bradford White RE2H50S6-1NCWT 50 Gal Heat Pump (old model), PDI (2026)
- Bradford White RE2H50S10-1NCWT 50 Gal Heat Pump, PDI (Plumbing Distributors Inc.)
- 50-Gallon Water Heater Installation Cost, Fixr (updated January 26, 2026)
- Save More with ENERGY STAR Certified Heat Pump Water Heaters, ENERGY STAR
- Energy Efficient Home Improvement Credit, Internal Revenue Service (updated April 28, 2026)
Before you call a plumber, compare these
- Home improvement costs in 2027: the complete price guide
- Water heater replacement cost for any brand
- What a tankless water heater costs installed
- How homeowners overpay for water heater repair
- What a plumber charges for the same fix
- Water softener cost: shelf unit or dealer system
Pricing method: prices were researched in November 2026 for 2027 planning and may change. Unit prices are online listings from plumbing supply retailers, before tax and shipping; installed figures combine those listings with national labor ranges and are our estimates. We found no announced 2027 price changes from Bradford White. This site is not affiliated with Bradford White or any retailer named. See our disclaimer.
















